Page 32
SmartOne C User Manual
Confidential & Proprietary Information
9100-0410-01 R2.4
• Vibration Detection Settings Button -
This button displays the Vibration Detection Settings window. This
window contains settings to define how the
motion sensor determines that the SmartOne is
in a state of vibration. These parameters include
Accelerometer Sensitivity, Vibration Sensor
Sensitivity, Time to be in a State of Vibration and
the Time to be in a State of Lacking Vibration.
○
SmartOne C/Solar: Accelerometer
Sensitivity.
The vibration sensor has a range of sensitivity
from 2 to 7 (2 being most sensitive and 7 being
least sensitive). The smaller the sensitivity
level, the more sensitive the motion sensor
would be to movement.
○
SmartOne B: Vibration Sensor Sensitivity.
The vibration sensor has a range of sensitivity
from 4 to 31 (4 being most sensitive and 31 being least sensitive). The smaller the sensitivity level, the more
sensitive the motion sensor would be to movement.
○
Time to be in a State of Vibration.
Time the motion sensor must be above the sensitivity level before being
in a State of Vibration. If the device senses continuous vibration for a period of time less than the specified in
this parameter, the device will ignore the vibration and will not enter into a State of Vibration.
○
Time to be in a State of Lacking Vibration.
Time the vibration sensor must be below the sensitivity level
before in a State of Lacking Vibration.
○
Abort Save/Save Settings buttons.
Perform requested function of settings.
• Outside Change of Location Area -
The parameters in this section define the functionality of the device while
outside its Change of Location Area.
○
Change of Location Alert Message -
The SmartOne can be configured to send a Change of Location Area
Alert message when the device leaves the Change of Location Area. This special message can be processed
by the back office application to send a notification to a cellular phone or to an email account that the asset
has left the
Change of Location Area.
The number of Change of Location Area Alert messages sent by the
device is set to 1 and cannot be altered by the user.
○
In Motion Interval -
This parameter determines the message interval once the SmartOne device is outside
the Change of Location Area and In Motion.
○
Change of Location Re-Center Message -
If Enabled, once the SmartOne creates a new Change of Location
Area after entering the At Rest State, it will send a Change of Location Re-Center Message.
