USER MANUAL
POSITION CONTROLLER THESI 320
MT02_A41_A_TH320_GIVI_ENG rev. E
Pag. 33/60
y E S
*
Press
to choose the desired selection
P 25
y E S
Press
to confirm and go back to
parameters selection
P 25
5 0.0
Press
to quit configuration and go back
to the positions display
2 0 0.0
Note:
for a proper use of ramps, it is necessary to correctly set the following parameters:
P11 = speed change value.
This has to be adequately set to allow the complete execution of the deceleration
ramp, based on the time set.
If the space set to change speed is too short, the deceleration ramp is interrupted
and positioning occurs abruptly. If it is too long, positioning occurs smoothly, but
much more slowly.
P19 = “speed change without stopping” option.
This has to be set on “Yes”, to allow the gradual switching from high speed to low
speed, following the deceleration ramp.
P26 = acceleration time.
This determines the time necessary for the axis to pass from 0 speed to high speed.
P27 = deceleration time.
This determines the time necessary for the axis to pass from high speed to low
speed. This has to be adequately set to allow the complete execution of the
deceleration ramp, based on the space set to change speed.
The acceleration and deceleration ramps (see parameters 26 and 27) are depicted in the
figure below:
t.acc
t.dec
V
mm
slow
fast
ok pos
speed change
Содержание THESI 320
Страница 1: ...User Manual Position Controller T TH HE ES SI I 3 32 20 0 www givimisure it...
Страница 57: ...USER MANUAL POSITION CONTROLLER THESI 320 MT02_A41_A_TH320_GIVI_ENG rev E Pag 57 60 NOTES...
Страница 58: ...USER MANUAL POSITION CONTROLLER THESI 320 MT02_A41_A_TH320_GIVI_ENG rev E Pag 58 60 NOTES...
Страница 59: ...USER MANUAL POSITION CONTROLLER THESI 320 MT02_A41_A_TH320_GIVI_ENG rev E Pag 59 60 NOTES...
