Gilat SkyEdge IIc, Руководство пользователя

Страница: 56 / 88

Installing and Connecting Modem Modem Configuration
54 CPE Installation and Pointing
Proprietary and Confidential
Figure 45: Dish Pointing Preparation Page 2
3. The modem is ready to respond to the signal power fluctuations that will occur while
you are pointing the dish.
If nominal azimuth happens to be set accurately, the above screen may look
slightly differently - showing that the signal is locked.
At this point, the transceiver starts emitting the Searching tone indicating that it is
seeking the carrier.
Regarding the beeping tones: view the accompanying video to get a good idea of
the different tones.
4. You can now leave the PC, move to the place where the dish is located, and start
pointing it. Continue to the Dish Pointing (on page
54 ) section.
Dish Pointing
Audio Indication
The transceiver has a built-in speaker that allows the system to indicate the state and
power of the signal.
The sounds emitted by the transceiver can be divided into the following types:

Searching – indicates that the CPE is in installation stage but the modem is not
locked yet.

Transition2Lock – a short two-second transitional tone indicating that the modem is
locked. Following this tone, the transceiver will immediately start to emit one of the
locked tones, according to the reception level.

Locked – a range of beeps indicating that the modem is locked on the satellite. Pitch
and stagger rate are proportionate to the level of reception: the better the
reception the higher the pitch and the faster the stagger rate.