Gerber SOLARA UV2, Руководство пользователя

Страница: 73 / 163

CHAPTER 4 73
Loading Inks and Materials
Error Message Material Possible Causes and Solutions
ERROR: MATERIAL SCAN
RT Shield Hole Small
Clean RT Hole Debris
Vinyl
Carriage located RIGHT shield hole, but the hole was less than ¼” in
width. Check for dust, debris, and/or partially obstructed shield hole
and/or slot in platen.
ERROR: MATERIAL SCAN
RT Shield Hole Large
Clean RT Hole Debris
Vinyl
Carriage located RIGHT shield hole, but the hole was larger than ½” in
width or the edge of the hole was not found after looking ¾”. Check for
dust or debris on shield surface. Check RIGHT shield alignment. Check
for proper alignment of material edge sensor.
ERROR: MATERIAL SCAN
Undetected RT Shield
Adjust Right Shield
Vinyl
Carriage scanned to the end of travel without finding the hole in the
RIGHT shield. Check RIGHT shield alignment. Check for dust, debris,
and/or obstructed shield hole and/or slot in platen. Check for proper
alignment of material edge sensor.
ERROR: MATERIAL SCAN
RT Shield Gap Found
Adjust Right Shield
Vinyl
Carriage scanning found a gap between the RIGHT shield and the
material edge. Check for proper placement of material. Check RIGHT
shield alignment.
ERROR: MATERIAL SCAN
LF edge too far away
Adjust Left Shield
Vinyl
or
Rigid
The LEFT edge of the material has been calculated to be more than 10”
from the left edge of the printable area of the printer. Check for proper
placement of material.
ERROR: MATERIAL SCAN
RT Edge Too Near LF
Adjust Right Shield
Vinyl
or
Rigid
The distance between the LEFT and RIGHT edges of the material have
been calculated to be less than 12”. Check minimum width of the
material. Check for proper placement of material. Check LEFT and RIGHT
shield alignment.
ERROR: MATERIAL SCAN
Motor Travel Error
Vinyl
or
Rigid
The motor system reported an error. Check for material jams. Check for
opened main cover or shutter. Check for loss of 48 volts. Run the
MotionJob and the EncoderJob diagnostics.