Gerber SOLARA UV2, Руководство пользователя

Страница: 87 / 163

CHAPTER 5 87
Printing Jobs on the GERBER SOLARA UV2
Attach the pieces to the
sign blank using Scotch-
Blue Painter's Tape for
Delicate Surfaces #2080
on the underside of the
material.
The joint between the sign
blank and the extension
should be tight – no more
than 1/8" (3mm)
3
Load the material into the GERBER SOLARA UV2 with the leading and trailing
extension pieces attached. Align the left edge of the material to the material guide on
the rear table. Make sure the front edge of the material is not covering the front
material sensor.
4
Adjust the left and right UV shields until they are 1/2" (12.7mm) away from the
material.
Note: Ensure that the left and right UV shields are spaced the same amount away from the
material on both sides or the print will not be centered.
5
Engage the pinch wheels and close the main cover. Adjust the beam height as
required.
6
Press F4, Rigid Bleed from the SELECT MATERIAL TYPE MENU that displays on the
GERBER SOLARA UV2.
Select material type
Rigid Bleed- F4
-Vinyl Rigid-
(CANCEL to Abort)