Gerber SOLARA UV2, Руководство пользователя

Страница: 65 / 163

CHAPTER 4 65
Loading Inks and Materials
Note: Once you cover up the rear material sensor the printer will produce an audible signal.
This sound simply means that the beam height needs to be adjusted. It is important to finish
aligning the material in the printer before adjusting the beam height.
8
Feed the material with the printable side facing up through the back of the printer over
the platen and under the pinch wheels so that it extends past the material line.
Pinch wheel
Material
Material line
Note: In order to print to within ¼” (6mm) of the leading edge of the rigid material, position
the material past the material line but do NOT cover the front material sensor when loading.
Prior to scanning the width, the printer will index the material over the sensor, scan the width,
then index the material back to the appropriate starting point.
9
The right-most pinch wheel should be located over the grit wheel roller nearest the
right edge of the material. The right edge of the material should be no more than ¼"
(6mm) beyond the edge of the right pinch wheel.
10
Position the UV shields ¼"- ¾" (6-20mm) away from each edge. The shields will not be
used to help hold down the material when printing but will still protect against over-
exposure to UV light.
RIGID MATERIAL
¼” – ¾”
(6 - 20mm)
¼”- ¾”
(6 - 20mm)
11
Holding the material in position, push in the load lever to engage the pinch wheels.
From the front, push the
material load lever in to
lower the pinch wheels.