Gerber SOLARA UV2, Руководство пользователя

Страница: 58 / 163

CHAPTER 4 58
Loading Inks and Materials
3
Load the material in the printer and align it on the platen as described in “Loading roll
material into the printer” on page 51.
4
Align the material to the take-up roll so that the leading edge is parallel to it while
maintaining alignment on the platen.
Align material parallel with
take-up tube.
Secure center of material
first.
Secure either end of
material.
5
Secure the material to the take-up roll with tape. Attach the material to the roll in the
center first, and then at either end.
6
Set the direction switch on the winding unit to the forward position (
⇓
), and then press
and hold the rotate switch until the material is wound approximately one and a half
times around the roll.
Winding Unit Controls
7
Continue printing as normal. The material will form a loose loop as printing continues.
The winding unit automatically activates when the loop of material passes in front of
the sensors. When the slack material is wound around the take-up roll, the winding
unit automatically stops.
Power switch
Rotate switch
Direction switch
(forward/backward)
Roller hub
Idler roller
Loop of material
passes in front of the
sensor and activates
the winding unit to roll
up the material