Gerber SOLARA UV2, Руководство пользователя

Страница: 79 / 163

CHAPTER 5 79
Printing Jobs on the GERBER SOLARA UV2
Printing a single job
Use Single mode to run one job at a time. Single mode allows you to:
♦
Change material between jobs
♦
Advance the material before the next job
After a job prints, the GERBER SOLARA UV2 waits for you to press F1, Start-Job again to begin
the next job once it is received at the printer.
Tip: You can print a job in Single mode to verify print output, and then switch to Multi mode
once the first job is finished to continue printing multiple jobs if you plan to use the same
material.
To run a single job
1
Press F2, Mode to toggle between Single and Multi mode. Choose Single.
MAIN MENU
Setup
F2 Mode: Single Operate
Job Status: No Job
2
Load the material in the printer. See “Loading the material” on page 42.
3
Send the job from your RIP software to the printer. When the job is received at the
printer, the Job Status changes to
Ready
, and
Start-Job
blinks (indicated by the dotted
box in the following diagram).
MAIN MENU
F1 Start-Job Setup
Mode: Single Operate
Job Status: Ready
4
Verify that the correct material is loaded in the printer and press F1, Start-Job.
5
Before the job starts to print a reminder window will appear reminding you to check
the settings for the lamp height and the pinch wheel force depending on the type of
material you loaded and the profile being used.
REMINDER: Set/Check REMINDER: Set/Check
Lamp Height: LOW POS Lamp Height: HIGH POS
Wheels: HIGH FORCE Wheels: LOW FORCE
(Press a Key) (Press a Key)
Default setup for vinyl material Default setup for rigid material
Check to make sure these setting are correct and press any key to start printing the job.
If you need to make adjustments use the following guidelines.