Gerber SOLARA UV2, Руководство пользователя

Страница: 54 / 163

CHAPTER 4 54
Loading Inks and Materials
Allowing the material
to extend about 12"
(30 cm) in front of the
printer makes it easier
to load.
Note: The material on the supply roll must not be slack to insure proper media feed. Re-roll
around the supply roll if necessary. Also check the tension on the feed roll brake.
9
Align the left edge of the material with the edge guideline located on the platen.
Edge guideline
Left edge of
material
10
Position the UV shields over the material so that the material fills half of each of the
holes in the side of both shields. This will position the shields ¼” (6mm) over each side
of the material and allow the shields to hold down the material edges during printing
so they do not curl or bend.
VINYL MATERIAL
¼”
(6mm)
¼”
(6mm)