Gentherm CSZ Blanketrol II 222S, Руководство по эксплуатации и техническому обслуживанию

Страница: 57 / 113

MAINTENANCE BLANKETROL II, Model 222S
OPERATION AND TECHNICAL MANUAL
Page 57 of 110
C. Fill the reservoir with the appropriate amount of Gigasept FF per the below chart.
D. Fill the reservoir with the appropriate amount of water per the above chart.
E.
Turn the unit on and circulate in Heating Mode @ 38
°C
for 15 minutes.
Note: The 15 minutes should not begin until the water reaches 38
°
C
.
F. Drain the unit as instructed in Step A.
G. Rinse the unit with Distilled Water three (3) times as described in Steps 4-6. Be sure
to omit Gigasept FF .
H. After the third rinse, drain the unit and fill the reservoir with distilled water and circulate.
I. Check the water with PH strips or other appropriate test method for Gigasept FF
detection. If Gigasept FF is detected, repeat Steps D-F.
J. If unit is to be returned to service , replenish reservoir(s) with the appropriate volume
of distilled water.
K. If unit is being placed in dry storage , continue with procedure.
L. When all fluid has been removed from the unit, disconnect the drain hose(s) and wipe
unit clean.
M. Unit is now ready for storage.
N. Document unit maintenance.
4-2.3. Fluid Circuit Disinfection/Dry Storage Procedure (For Circulating Water Units
Utilizing CE Approved Maranon H)
Note: Maranon H is a Product of Ecolab and is not available in the United States.
The following procedure disinfects the fluid circuit in these products. The required tools/supplies
are appropriate drain hose(s) and/or hose connector(s), Maranon H, distilled water, and the
appropriate AC electrical power
PROCEDURE:
A. Drain the water from the reservoir as described in Section 4-2.4.
B.
Turn unit
off (“O” position)
.
C. Fill the reservoir with the appropriate amount of Maranon H per the below chart.
UNIT Gigasept FF WATER DURATION
BLANKETROL II, Model
222S 800 Milliliters 7.6 Liters 15 Minutes
UNIT MARANON H WATER
BLANKETROL II, Model
222S 227 Milliliters 7.6 Liters