Gentex HGU-56/P, Инструкция по эксплуатации и обслуживанию

Страница: 64 / 86

5. Referring to Figure 3-19 ,
bend the arms of the jack
holder slightly away from the
connector, and remove the
connector from the jack
holder.
6. Referring to Figure 3-20 ,
remove the two screws
attaching the jack holder and
plate to the rear of the helmet.
7. Referring to Figure 3-21 ,
remove the grommet from the
helmet, and remove the entire
communications cord from the
helmet through the grommet
hole.
Installation
1. Referring to Figure 3-21 ,
insert the replacement
communications cord from the
outside of the helmet through
the grommet hole so that only
the connector and the
grommet are on the outside of
the helmet.
2. Insert the grommet so that it is
firmly seated in the hole.
3. Referring to Figure 3-20 ,
reattach the jack holder and
plate to the helmet with the
two screws.
4. Referring to Figure 3-19 ,
insert the connector into the
jack holder, and bend the
arms of the jack holder slightly
to help hold the connector in
place.
(Continued on next page)
58
Figure 3-19. Jack Holder and Connector
Jack holder
Connector
Arms
Arms
Figure 3-20. Jack Holder, Plate, and Screws
Screws
Jack holder
Plate
(inside
helmet)
Figure 3-21. Connector and Grommet
Grommet
Communications cord