Gentex HGU-56/P, Инструкция по эксплуатации и обслуживанию

Страница: 14 / 86

2-3.1 Installing SCL
To install the SCL, you remove the
TPL from the helmet and insert the
SCL in place of the TPL.
Tools and Materials Required
SCL in one of the following sizes
(to match helmet size):
•
02D11531-8 (XX-Small)
• 02D11531-9 (X-Small)
•
02D11531-10 (Small)
•
02D11531-11 (Medium)
• 02D11531-12 (Large)
•
02D11531-13 (X-Large)
Procedure
Install the SCL ( Figure 2-3) as
follows:
1. Remove the TPL from the
helmet.
2. Referring to Figure 2-4 , place
the SCL in the helmet
3. Ensure that the holes in the
SCL are aligned with the holes
in the energy-absorbing liner
as shown in
Figure 2-5. The
SCL should seat down against,
and align with, the front edge
of the energy-absorbing liner.
4. Proceed to Paragraph 2-4
(beginning on Page 27) to
check the fit of the helmet.
NOTE: The SCL usually does
not require custom-fitting.
However, the SCL may be
custom-fitted, if necessary, as
described in Paragraph 2-6
(beginning on Page 36).
8
Figure 2-3. SCL
Figure 2-4. Installing SCL
Figure 2-5. Aligning SCL