Gentex HGU-56/P, Инструкция по эксплуатации и обслуживанию

Страница: 17 / 86

6. Attach the 2 x 2-inch pile fastener (supplied with the ANVIS mounting hardware kit) to the
visor housing at the front of the helmet as shown in Figure 2-10 . This fastener will anchor
the connector.
7. Attach the two 2 x 3-inch pile fasteners (supplied with the ANVIS mounting hardware kit) to
the back of the helmet as shown in Figure 2-10 . These fasteners will hold the battery pack.
8. Referring to Figure 2-10 , attach the mount to the ANVIS dual visor assembly as follows:
a. Align the locating pins with the slots in the mounting platform on the visor housing.
b. Insert the pins into the slots, and pull the mount down until it clicks into place.
c. Attach the hook fastener on the connector to the pile fastener on the visor housing.
9. To remove the mount from the visor housing, depress the tab on top of the mounting
platform, and lift the mount up and away from the housing.
11
Pile fasteners, 2 x 3
BACK OF HELMET
Pile
fastener,
2 x 2
Hook fastener on connector
ANVIS mount
Visor housing
Tab
Figure 2-10. ANVIS Mount and Pile Fasteners Installed
FRONT OF HELMET