Gentex HGU-56/P, Инструкция по эксплуатации и обслуживанию

Страница: 29 / 86

12. Referring to Figure 2-36 ,
attach a striker to one side
of the helmet by using one
screw and a post through
the lower hole of the striker
and the drilled hole in the
helmet, applying a drop of
white glue to the threads of
each screw. Leave the
screw just loose enough to
allow the striker to rotate.
13. Repeat Step 12 for the other
side of the helmet.
14. Reattach the dual visor
assembly to the helmet.
Referring to
Figure 2-37 ,
use the two downstop
locking screws (one on each
side of the visor) to adjust
the visor downstop to the
lowest position.
15. Referring to Figure 2-38 ,
attach the MFS to the striker
and latch the MFS into place
as follows:
a. On one side, position the
pin on the MFS latch into
the slot of the striker,
and flip the latch against
the helmet shell. Ensure
that the latch is locked in
place.
b. Swing the MFS to the
closed position on the
other side, and fasten
the other latch in place.
Continued on next page
23
Figure 2- 36. Striker Attachment
Figure 2- 37. Downstop Locking Screws
Figure 2-38. MFS Attachment to Helmet
Screw
Striker
Post
Helmet
Drilled hole
Downstop
locking screw
Downstop
locking screw
Pin
Latch
Striker
Slot
MFS
Latch
Striker