Gentex HGU-56/P, Инструкция по эксплуатации и обслуживанию

Страница: 40 / 86

15. To help prevent the visor lenses from fogging when the MFS is worn, use Sea Drops
ä
anti-fogging solution as follows:
a. Apply two drops of anti-fogging solution to the inside surface of each lens.
b. Rub the solution over the entire surface of the lens.
c. Wait 10 seconds, then buff with a Micronet
ä
microfiber cloth or any soft, dry cloth until
the lens is clear.
NOTE: Sea Drops ä and Micronet ä are available from McNett Corporation, 1411 Meador Ave.,
Bellingham, WA 98229, phone 360-671-2227. (www.mcnett.com)
16. Remove the helmet as follows:
a. Loosen the chinstrap by separating the free end from the chin pad and pushing the free
end of the strap back through the toggle as needed.
b. Grasp the helmet in the earcup areas, and flex the helmet just enough to clear the head.
c. Rotate the helmet forward and off the head.
17. After the first flight, recheck and adjust as necessary the helmet straps, TPL (or SCL), and
earcups as necessary to achieve a snug fit.
NOTE: If the wearer cannot be fitted according to these fitting instructions, contact Gentex
Corporation.
34
When using the anti-fogging solution described below, avoid getting the liquid
solution into the eyes. Solution will irritate and may burn the eyes. In case of eye
contact, flush with fresh water for 15 minutes. Contact a physician if irritation persists.
See the package for other directions.