Genesis single line, Руководство по эксплуатации и обслуживанию

Страница: 67 / 103

MAINTENANCE
4 -8 96622 Issue 4.0 Jan 01
CLEAN AND INSPECT PRINT HEAD
Place all parts EXCEPT the ”O” rings and the rear manifold seal in an ultrasonic
cleaner filled with 3400 solvent. Soak parts clean for at least 30 minutes. Inspect
all parts for dirt, contamination and damage. Replace defective parts.
Check the array plate for 10 clean openings. Replace any array plate if bent or
broken.
PRINT HEAD ASSEMBLY
Place manifold ”O” ring on the manifold, making sure the ”O” ring is seated in
the groove of the manifold with the flat side exposed. Place the screen plate,
then the screen on the manifold. Install the nozzle module onto the manifold
using the alignment pins on the manifold to align it with the nozzle module.
Place the rear manifold seal onto the rear side of the manifold. Place the rear
plate onto the manifold followed by the back plate.
Install the (4) screws through the manifold, nozzle module and into the front
clamp plate. Place the array plate ”O” ring, then array plate with the square hole
at the bottom nearest to the ink inlet of the print head. Install the hanger mount
bracket and secure into place with the hanger mount spring. Install the print
head cover and securing screw.
Reassemble the print head onto the mounting bracket.
CONTROLLER MAINTENANCE
If the Controller alerts the operator of a LOW BATTERY condition, it will be
necessary to replace the (4) AA battery cells. These cells are located in the
battery compartment located on the bottom side of the controller. See the
following diagram for reference.
BATTERY INSTALLATION