Genesis single line, Руководство по эксплуатации и обслуживанию

Страница: 64 / 103

MAINTENANCE
4 -5 96622 Issue 4.0 Jan 01
Openings
Thoroughly flush the array plate with 3400 solvent using the 4 oz. bottle with the
spout. Hold the array plate up to a light and
check that all 10 openings are clear If
necessary, scrub with the ‘acid brush” that is
included with the Start-up Kit.. Check that
the plate is not bent or broken. Place the
”O” ring onto the nozzle module with the
flat side facing outward. Install the array
plate onto the nozzle module with the
SQUARE hole at the bottom, nearest to the ink inlet.
Install the hanger mount bracket and secure the hanger mount bracket spring in
place.
Using the Start-up kit components, install the 1 1/2” tubing on the syringe, fill
the syringe with clean 3400 solvent.
CAUTION: NEVER FILL THE SYRINGE WITH SOLVENT WITH THE
FILTER IN PLACE. ANY CONTAMINATION IN THE SOLVENT WILL BE
CAUGHT IN THE FRONT OF THE FILTER AND CAN BE INTRODUCED
INTO THE PRINT HEAD.
Install the filter (crown of filter away from syringe) and the other 1 1/2” tubing
onto the syringe, tubing and filter. Connect the tubing to the ink inlet on the
print head. Slowly depress the plunger on the syringe. This will force solvent
through the print head nozzle orifices. Repeat flushing procedure until clear
solvent is emitted from the nozzles.
Using the syringe, as described above, slowly flush clean 3400 solvent through
the print head again. Check that 10 distinct straight streams of solvent are
emitted from the print head. If there are not 10 straight streams, repeat the
flushing procedure. If repeated flushing can not result in 10 straight streams, the
print head will have to be disassembled and cleaned. If the 10 streams are
present, reassemble the print head following the previous steps in reverse order.