Genesis single line, Руководство по эксплуатации и обслуживанию

Страница: 33 / 103

OPERATIONS
3 -7 96622 Issue 4.0 Jan 01
TURNING ON THE PRINT STATION FOR THE FIRST TIME
The first time the print station is turned on,
the LCD should look like the illustration at
left. This “screen” is also the default
screen. The key elements of the screen are
identified: the print enable indicator, the
line speed, the product direction, and the
character width indicator.
Note: In the event you desire to return to
the default condition, turn off the print
station. While simultaneously depressing the print enable and cycle keys on the
print station, turn on the print station and hold keys for 5 seconds - then release.
CAUTION
: This will wipe out all programmed instructions.
The presence of the print enable indicator as shown above, means the print head
is ready to print. If however, it is desired to have the print head powered up but
not able to print (in a “print disabled mode”), press the print enable/disable key
on the print station keypad. This action results in the disappearance of the print
enable indicator and the appearance of the print disable indicator on the LCD.
The print disable indicator looks like this:
The line speed number, 50, has been set in the factory. The value of line speed
varies from 1 to 255 feet per minute (fpm). One way to increase or decrease this
number is by using the arrow keys on the print station keypad. Changing this
value with the Controller is discussed later in the section.
The arrow indicates the direction of product moving on the line. In this case, the
product is moving from left to right with respect to the back of the print head.
The method used to change product direction is given later in this part of the
manual.