Generac Power Systems G007144, Руководство по установке

Страница: 19 / 68

Unpacking and Inspection
Installation Guidelines For 50 Hz Air-Cooled Generator Sets 13
Intake Side Panel Removal
See Figure 2-6 . Intake side panel (A) must be removed
to access battery compartment, fuel regulator, and sedi-
ment trap.
Figure 2-6. Remove Intake Side Panel
1. Raise lid and remove front panel.
2. Use a 4mm hex key to remove two mounting
screws (B) and L-bracket screw (C).
3. Lift intake panel up and away from generator set.
4. Inspect for any hidden freight damage. Contact
freight carrier if damage is present.
NOTE: Always lift intake side panel straight up before
pulling away from enclosure. Do not pull panel away from
enclosure before lifting up (D).
Customer Connections and Loose
Parts
See Figure 2-7 and Figure 2-8 for customer connections
and loose parts location. Figure 2-10 illustrates parts
shipped loose.
Figure 2-7. Customer Connection Area and Loose
Parts Location
Rear Connections
Figure 2-8. Rear Connections
NOTE: Generator set is equipped with a Wi-Fi module.
See Wi-Fi module owner’s manual for further instruction.
005629
B
A
C
D
005629
A Customer electrical connection area
(behind the access panel)
B Fuel regulator with sediment trap
C Battery compartment (battery not supplied)
D Positive (+) and negative (-) battery cables
E Location of “Loose Shipped Parts”
A Wi-Fi module
B Main AC/Control wiring hole for 1-1/4 in conduit
C Main AC/Control wiring hole for 3/4 in conduit
D Fuel connection hole
A
E
C
D
B
005773
B
C
D
005774
A