Generac Power Systems G007144, Руководство по установке

Страница: 18 / 68

Unpacking and Inspection
12 Installation Guidelines For 50 Hz Air-Cooled Generator Sets
IMPORTANT NOTE: DO NOT perform this step until
the generator set has been transported to the instal-
lation site. See
Transportation Recommendations .
4. See Figure 2-3 . Remove bolts and pallet brackets
(A). Exercise caution when removing generator
set. Dragging it off pallet will damage base. Gener-
ator set must be lifted from the wooden pallet to
remove.
NOTE: Bolts and pallet brackets are provided only for
shipping purposes and can be discarded after removal.
Figure 2-3. Pallet Bracket Locations
Opening The Lid
Proceed as follows to open generator set lid:
1. Use keys to open generator set lid.
2. See Figure 2-4 . Two locks (A) secure lid; one on
each side. Press down on lid above side lock, and
unlock latch to correctly open lid.
Figure 2-4. Opening The Lid
3. Repeat for other side. Lid may appear stuck if pres-
sure is not applied from top.
NOTE: Always verify side locks are unlocked before
attempting to lift the lid.
Enclosure Panel Removal
Generator set installation requires removal of front panel
and intake side panel. The following procedures outline
the removal process. Remove these panels when neces-
sary.
Front Access Panel Removal
See Figure 2-5 . Remove front access panel (A) by lifting
straight up and out once lid is open.
Always lift front access panel straight up before pulling
away from enclosure. Do not pull panel away from enclo-
sure before lifting up (B).
Figure 2-5. Remove Front Access Panel
A
000426
A
A
005772
005628
A
B
005628