Watchdog 100 Instruction Manual
34
© 2017 Geist
GM1118 Watchdog 100 Instruction Manual
To add a new Alarm or Warning Event:
1. Click the Add/Modify Alarms & Warnings button:
Figure 3-8
Adding Alarms and Warnings
2. Set the desired conditions for this Event as follows:
a. Select the
Name
of the device you wish to set an Event on.
b. Select the measurement (temperature, humidity, etc.) you want to
Trigger
the Event.
c. Set the
Severity
level ("Warning", or "Alarm") for this Event.
d. Select the threshold
Type
, "high" (trips if the measurement goes above the
threshold) or "low" (trips if the measurement goes below the threshold).
e. Type in the desired
Threshold Value
(any number between -999.0 ~ 999.0 is valid).
f. Type in the desired
Clear Delay
time in seconds. Any value other than "0" means
once this Event is tripped, the measurement must return to normal for this many
