Gehl CTL55, Руководство оператора

Страница: 100 / 202

TRANSPORT
98
WARNING
The machine may roll or tip over or fall
while loading or unloading it. Take the
following precautions:
�
Select a firm, level surface and
keep sufficient distance from road
shoulders.
�
Use loading ramps of adequate
strength and size. Maintain the slope of
loading ramps to 15 degrees or less.
�
Keep the truck bed and loading ramps
clean of oil, clay, ice, snow, and other
materials that can become slippery.
Clean the tracks.
�
Never change course on the ramp.
When loading or unloading the machine, be
sure to use ramps and follow the procedure
below:
1. Apply the truck’s parking brake and place
chocks (stoppers) against its tires.
2. Fasten the ramps securely to the truck
bed so that they will not come off. Set the
ramps to an angle of 15° or less.
3. Move the machine up or down the ramps
with the bucket end facing downward.
4. Line up the center of the truck bed with
the center of the machine and the center
of the ramps with the center of the
crawlers.
5. Make sure the bucket does not hit the
ramps.
6. Lower the engine speed.
7. Determine the direction on the ramps,
then slowly travel up or down the ramps
in 1st speed (low speed), following the
signals of a flagman.
8. Load the machine properly at the
prescribed position on the bed.
Refer to page 99, “Transporting
Position.”
T7F001
E4F001
Loading and Unloading
Fasten to the suspension fitting
Ramp
15° or less
Distance between ramps
Stopper