Assembly
Mudguards assembly
2018-9015-003
03-2015
*
*
Note!
Apply silicone on the brackets, on the supports and on mudguard
sections to avoid rattling noise caused by vibration. Regular silicone
is recommended.
Install mudguard sections using carriage bolts, flat washers and locknuts in the
following order:
● Fasten sections #5 and #6 on supports;
● Fasten bottom part of section #1 on support;
● Fasten bracket 'F' on upper part of section #1;
● Fasten section #2 between sections #1 and #6;
● Fasten bottom part of section #3 on support;
● Fasten bracket 'F' on upper part of section #3;
● Fasten section #4 between sections #3 and #5;
● Tighten all nuts;
● Allow the silicone to dry before moving the spreader;
● Repeat these steps to install the mudguards on the other side of the
spreader.
*
On a EL44-6D spreader, one additional straight section is required
between sections #5 and #6.
