– 42 –
Drawers
The freezer drawer and the convertible drawer
each utilize a magnetic reed switch to signal the
main board the drawer is open. This reed switch is
used to operate the LED lighting for the drawer and
adaptive defrost input. The magnet is snapped into
the back of the left slide.
The reed switch is located behind a cover in the left-
rear corner of the liner. The cover is attached with a
Phillips-head screw.
When installing the reed switch, use standard, moist
environment splicing procedures.
Magnet
Reed Switch
Note:
To remove the convertible drawer, the freezer
drawer must be removed
fi
rst.
To remove either drawer:
1. Pull the drawer out and remove the front-corner
thumb screws.
2. Using a small,
fl
at blade screwdriver, pry up
each lock tab, lift up the latch tab, and then pull
the cap forward.
3. Lift the drawer bin off the slides.
4. Lift the drawer front and drawer rails off the
slides and remove the assembly from the
cabinet.
Note:
Each freezer drawer slide is attached to
the cabinet with 6 Phillips-head screws. Each
convertible drawer slide is attached with 8 Phillips-
head screws.
Cap
Latch Tab
Lock Tab
