– 37 –
(
Continued next page
)
To remove the wine reserve evaporator cover:
1. Pull the mullion gasket (from either side)
carefully out from the retainer channel.
2. Remove four T-20 Torx screws from the bottom
of the center mullion front.
Wine Reserve Evaporator Cover
Note:
The
wine unit has upper and lower cooling
zones that are separated by a center mullion strip.
Accessing the evaporator requires removal of
the center mullion strip and the upper and lower
evaporator covers.
Mullion Gasket
Center Mullion
Mullion Gasket
Upper Cover
Lower Cover
Retainer Channel
3. Pivot the center mullion cover out at the bottom,
and then lift the cover off the mullion.
4. Remove a T-25 Torx (5/16-in. hex-head) screw
from each side of the mullion.
5. Grasp and pull the center mullion out
approximately 2 inches.
Disconnect
6. Underneath the mullion at the right-rear corner,
locate and disconnect the mullion LED light
harness.
7. Pull the center mullion out from the cabinet.
Mullion Cover
