4400_0060
enFlow Service Manual Rev. F 04/12
Page 14 of 36
4.
Display Panel
a.
On the display panel remove the two screws (4 and 5) at the end of the panel next to the display
screen (see
Diagram 7)
.
b.
There are three other screws (1-3) that need to be loosened half-way on this panel.
c.
Pull the display panel away from the fan assembly.
d.
Take a pair of pliers and gently pull out battery.
e.
Insert new battery. Push firmly into place.
f.
Reinsert and tighten all screws on the display board
5.
Reassembly
a)
Reseat fan assembly and display board (see
Diagram 5)
.
b)
When reseating display board, make sure that all wires are between the two white posts (see
Diagram 6)
.
c)
When reseating the fan assembly on the display board end, make sure that the wires are
inside
the corner post_1 (see
Diagram 5)
and wrap around the edge of the fan assembly.
d)
On the opposite end from the display board, make sure the wires go
around
the outside of the
corner post_2 (see
Diagram 5)
.
e)
Reinsert and tighten the 2 screws for the power assembly (see
Diagram 5)
.
f)
Attach bottom cover; reinsert and tighten the six related cover screws (see
Diagram 3)
.
g)
Reinsert pole clamp screw.
h)
Dispose of the old battery in accordance with any government regulations in affect in your area.
Diagram 7
