GE Mini COM Express 10, Справочник по аппаратуре

Страница: 15 / 82

2 Unpacking and Inspection
This chapter describes unpacking, initial inspection, and required preparation
considerations prior to using the mCOM10-L1500. Follow the procedures provided in this
chapter to verify proper operation after shipping and prior to system integration.
2.1 Electrostatic Discharge
Electrostatic Discharge (ESD), the discharge of static electricity, is a major cause of
electronic component failure. The module has been packed in a static-safe bag to protect
the board from ESD. Before removing the module or any other electronic product from its
static-safe bag, be prepared to handle it in a static-safe environment.
Warning
Static-sensitive devices; handle only at static safe work
stations.
Caution
This is an FCC Class A product for use in an industrial
environment. In a home or residential environment, this
product may cause radio interference in which case the
user may be required to take adequate measures.
Caution
Drain static electricity before you install or remove any
parts. Installing or removing modules without observing
this precaution could result in damage to this and/or
other modules in your system.
Wear a properly-functioning anti-static strap and make sure you are fully grounded. Any
surface upon which you place the unprotected module should be static-safe, which is
usually facilitated by the use of anti-static mats. From the time the board is removed from
the anti-static bag until it is in the card carrier and functioning properly, extreme care
should be taken to avoid zapping the board with ESD. Be aware that you could zap the
board without knowing it; a small discharge, imperceptible to the eye and touch, can often
be enough to damage electronic components. Extra caution should be taken in cold and
dry weather when electrostatics easily builds up.
Only after ensuring that both you and the surrounding area are protected from ESD,
carefully remove the board or module from the shipping carton by grasping the module
on its edges. Place the board, in its anti-static bag, flat down on a suitable surface. You
may then remove the board from the anti-static bag by tearing the ESD warning labels.
Unpacking and Inspection GFK-2896 Hardware Reference Manual 15
For public disclosure