GE DTR GEK-106305A, Инструкция по эксплуатации

Страница: 43 / 91

4. PROGRAMMING THE UNIT
42 DTR Digital Tap Changer Controller GE—106305A
CONFIGURABLE INPUTS
Tap 12
Tap 13
Tap 14
Tap 15
Tap 16
Tap 17
Tap 18
Tap 19
Tap 20
Tap 21
Tap 22
Tap 23
Tap 24
Tap 25
Tap 26
Tap 27
Tap 28
Tap 29
Tap 30
Additionally to these possibilities, we can use programmable inputs for creating logic schemes using logic
AND/OR/NOT gates with the inputs, and assigning them to outputs. For creating these schemes, we must program
inputs as “Void input”.
The following lines detail the operation of each input:
•
Selection table 1 : This input is activated by level, and it’s used for switching the active settings table. Please
refer to section 2.5 for further details.
•
Selection table 2 : As in the previous case.
•
Interlocking 1: Used for blocking the operation of the regulation automatism (in automatic mode).
•
Interlocking 2: Used for blocking the operation of the regulation automatism (in automatic mode).
•
Regulator Alarm: Signals the activation of the Alarm input in the commuter
•
BCD_1 to BCD_6: Used for informing the unit, using BCD (Binary Coded Decimal) coding, of the tap where the
OLTC is located.
•
Tap-up: This input commands a tap increase.
•
Tap-down: This input commands a tap decrease.
•
Automatic: Command for switching to the Automatic operation mode.
•
Manual: Command for switching to the Manual operation mode.
•
Remote: Command for switching to the Remote operation mode.
•
Local: Command for switching to the Local operation mode.
•
Stopped: Command for stopping the regulation automatism.