GE Compax 40E, Руководство по обслуживанию системы

Страница: 107 / 139

System Service Manual − SYSTEM COMPAX 40E, CE Marked
GE HEALTHCARE with MPH 50/65/80 (including XT, RS 85 and Tomo − Link)
REV 9 DIRECTION 2154260 − 100
96
SECTION 2
OPERATIONS
Note: At the end of each operation of periodic maintenance, the complete ”functional tests” procedure must be ap-
plied (refer to Chapter 4 of this manual).
2-1 Table
See SM ref.: 2150299 − 100, Chapter 6
2-2 MPH Generator
See SM MPH ref.: 2137354 − 100, Chapter 4.
2-3 XT
See SM 2118733 − 100, Dir. 2116793 − 100
2-4 RS 85
See SM 03277223, Chapter 4
2-5 SG60
See SM 2150293 − 100, Chapter 5
2-6 SG100
See SM 2150297 − 100, Chapter 5
2-7 Tomo − Link
See SM 2133821 − 100, Chapter 19
2-8 Collimator
The following PM procedure applies to Ultranet “SM” Collimators. You can also reference the following
directives for this procedure.
− SM Y00W21L.04, Chapter 10
− SM Y00W20L.04, Chapter 10
2-8-1 Equipment Required for Collimator PM
− Standard tools
− LUBRIPLATE 630 − AA Grease (or equivalent)
− Set of wrenches (furnished with the collimator and left on site)
> Hook wrench for collimator mounting ring (Part No. 45298477)
> Hex adapter (Part No. 2223142)
> Two wrenches for 10/32” and 9/16” screws (Part No. 45298477)
> Two hook wrenches for 25,, castle nuts (Part No. 45298476)
> One knob position tool (Part No. 2188963)
− Set of wrenches (not furnished)
> Torque wrench (for torquing the mounting ring): 3/8” square drive torque of 20 to 30 Nm (180 to
270 in lbs.)