11
R E LI AG E A R® LV SG
LO W VO LTAG E S W I TC H G E A R
Lifting plates must
be removed where
sections are joined
—
Front view
—
Side view
Roller
—
11
Method of rolling
equipment into place
—
11
Notice:
If shipping skids are removed prior to final
placement of equipment, rollers may only be used
to move the equipment in a direction parallel to
the front.
6. Carefully lower the gear until it rests on the
rollers (Figure 10).
7. While carefully pushing the switchgear to its final
site position, the rollers that are freed from the
rear of the switchgear are then repositioned at
the forward end. This procedure should be
continued until the switchgear is in its final
location (Figure 11).
8. When the switchgear is in its final position,
remove all lug bolts holding the shipping skids
to the switchgear line-up.
9. Insert the tines of the forklift at one end of
the line-up, raise slightly, and remove the
loose rollers.
10. Lower the end of the gear carefully
to the floor.
11. Raise the other end of the line-up slightly and
remove the remaining roller at that end.
DANGER
WARNING
CAUTION
NOTICE
