![background image](http://html1.mh-extra.com/html/gbc/fusionpunch-ii/fusionpunch-ii_user-manual_571156022.webp)
1-10
Getting Started
5
Pause/Interrupt
The Pause button is used to stop, or interrupt, a job that is
currently running. This may become necessary if a problem
occurs or if an adjustment is required.
Note:
If running in
Cycle Up
mode, when you press the Pause/Interrupt
button, the LCD will display: "
Delayed Stop
."
Press the Start or the Stop/Reset buttons to resume the printer and
FusionPunch II.
6
Stop/Reset
The Stop/Reset button is used to halt all operation of the
FusionPunch II, if it should become necessary. It is also used
to reset the machine after an error has been corrected.
7
Arrows
The arrow controls at the upper right-hand corner of the
Control panel are used to scroll the information on the LCD
display screen up or down, or, left or right. They are also used
to change the different run modes and destinations.
8
LCD Display Screen
The LCD Display Screen displays the current status of the
FusionPunch II, to include operating mode and any error
messages that may occur. Also, service personnel use the
display to run and interpret diagnostic codes.
"LCD DISPLAY
SCREEN"
Содержание FusionPunch II
