![background image](http://html1.mh-extra.com/html/gbc/fusionpunch-ii/fusionpunch-ii_user-manual_571156056.webp)
2-14
General Procedures
Starting a Job
Punching and Stacking
n
For punching and stacking the 11" edge in the GBC Stacker without a
Bypass installed, follow the procedure below.
n
For punching and stacking the 11" edge in the Xerox High Capacity
Stacker, go to Starting a Job for Bypassing to a Downstream device
(Page 2-20.)
n
For punching and stacking the 8.5" edge, go to Starting a Job for
Bypassing to a Dowstream device (Page 2-20.)
To prepare for starting a printing job and sending it to the FusionPunch II,
perform the following procedures.
1
Set up the FusionPunch II according to the job requirements (For
FusionPunch II setup, refer to the Getting Started section,
On-line /
Off-line
).
2
From the
DocuSP Print Services
screen, open the
Printer Manager
window and click on the
Finishing
Icon.
Figure 2-10: The Finishing Window
Содержание FusionPunch II
