GBC FusionPunch II, Руководство пользователя

Страница: 69 / 132

Using the GBC Stacker 2-27
2
To lower the Stacker Tray for unloading, go to the FusionPunch II Control
Panel and do the following:
1
If in
Cycle Up
mode:
n
and only one stacker is installed, wait for the FusionPunch II and
the host printer to cycle down.
GBC Fusion Full Stop
will be
displayed in the LCD Display Screen when the machines have
cycled down.
n
and the system is equipped with a Second Offset Stacker, you will
not have to wait for the the punch and the printer to cycle down. By
setting the destination to
Stack 1
or
Stack 2
the FusionPunch II
will automatically switch between the stackers as long as the next
stacker’s tray is in the up position.
2
Press the
Raise/Lower Stacker #1
button to lower the tray of the
first (#1) Stacker in the system.
Press the
Raise/Lower Stacker #2
button to lower the tray of the
second stacker in the system (if a second Stacker is installed).
3
Open the Stacker Door and remove the punched copy.
4
Close the Stacker Door.
5
Press the
Raise/Lower Stacker
button(s) to raise the Stacker tray
(or trays) back up to the top position. The Punch will not start with the
Stacker tray(s) down. The following applies to Stackers:
n
If a single Stacker is used and its tray is down, the Punch Control
Panel will display a message telling you to empty the Stacker. The
Punch will not start until the tray is up.
n
If more than one Stacker is employed in the system, at least one of
the Stackers’ trays must be up to start the Punch. However, when
that Stacker fills up, the Punch will not switch to the other Stacker
if its tray is down. Instead, it will stop the Printer and display a
message telling you to empty the Stacker.