GBC FusionPunch II, Руководство пользователя

Страница: 120 / 132

A-26 Appendix A
DocuTech 135 Host Machine Enablement
1. Open the
Job manager
.
2. Log in with your user ID and password.
3. Go to the top right corner of the keyboard and press
Diagnostics
.
NOTE: If you have a job in the printer queue, the DocuTech will prompt you to
switch immediately.
4. Press
yes
.
5. After
Diagnostics
have been invoked, select
DC Controller
, found in the
top left corner of the screen.
6. Go to
Controller DC 105
and enable
BYPASS TRANSPORT
by selecting
“
other
”.
7. On the next screen, select
DC 131 NVM Read and Write
.
8. Select
FBN
and enter the values for the specified FBN nodes, as listed
below.
FBN settings for DocuTech 135
• FBN 186 = 0: This is the End of Set Offset Time
• FBN 188 = 100: This is the End of Set Pulse Width
• FBN 191 = 0: This is the lead edge and trail edge trigger
• Lead edge = 0 and Trail edge = 1
After you have entered the values, you must close the call. To do this:
1. Select
SCP
, found in the top left corner of the screen.
2. Go to the bottom left corner of the screen and click
Close Call
.
NOTE: The DocuTech will prompt you to enter service call information.
3. Enter
Other
for the cause of call.
4. Enter
Incomplete Other
for the status of call.
5. Go to the bottom right corner of the screen and click
Close Call
.
6. Click
Yes
to close call.
Click the
Printer
icon and then
Reset
. The
End of Set
signal will be timed
correctly with the FusionPunch and the Offset stacker.