GBC FusionPunch II, Руководство пользователя

Страница: 62 / 132

2-20 General Procedures
Starting a Job
Bypassing to a Downstream device
To prepare for starting a printing job and sending it to the Bypass
Destination, as well as the Downstream device, perform the following
procedures.
1
Set up the FusionPunch II in the Bypass Destination, as well as the
correct Punch mode (For FusionPunch II setup, refer to the Getting
Started section,
On-line / Off-line
). Once the FusionPunch II is setup
for the application, go to the Downstream device and enable it for
On-line operation.
2
From the
DocuSP Print Services
screen, open the
Printer Manager
window and click on the
Finishing
Icon.
The
Finishing
Window will display, defaulted to the
Finishing
tab, as
shown below.
Figure 2-18: The Finishing Window