GBC FusionPunch II, Руководство пользователя

Страница: 55 / 132

Setting the Backgauge 2-13
2
3
Open the Right Punch Door.
4
Use the Backgauge Adjustment Knob to correct the margin, as shown in
Figure 2-9. Adjust as follows:
n
To
increase
the margin between the leading edge of the copy and
the punched holes, turn the Backgauge Adjustment Knob
counterclockwise
.
n
To
decrease
the margin, turn the adjustment knob
clockwise
.
5
Turn the Backgauge Adjustment Knob one click at a time and check the
margin at each position. Use the Single Sheet Feeder to run test paper
through the Punch. To do this:
a)
Set up the FusionPunch II in the following modes and destination;
"
Offline / Punch / Stack 1
" (or
Stack 2
).
b)
Ensure that the Stacker Tray is in the TOP position. If it is not,
press the
RAISE/LOWER STACKER 1
or
2
button either
once or twice until the Stacker moves up to its TOP position. The
Punch will not start with the Stacker Tray down.
c)
Press
START
.
d)
Into the Single Sheet Feeder, feed a sheet of paper of the size
required for the job.
e)
Press the
STOP/RESET
button.
f)
Press the
RAISE/LOWER STACKER 1
or
2
button to
lower the Stacker.
g)
Open the Stacker Door and remove the punched sheet of paper.
h)
Close the Stacker Door and press the
RAISE/LOWER STACKER
1
or
2
button to raise the tray.
6
Repeat Steps 4 and 5 until the margin is correct.