F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999
Page 5 - 12
Operations
d) Press RESET. The front control panel will
illuminated.
R e s e t
5.3.2 Film loading
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
W A R N I N G
a) Raise the rear safety shield if placing a roll of
laminate onto the upper unwind shaft.
b) Lift the clevis pin located in the saddle of the
upper unwind shaft.
c) Swing the unwind shaft out enough to slide the
roll of laminate over the core chucks and onto
the unwind shaft. Refer to Figure 5.3.2
INFORMATION
Twisting the roll of film while sliding
makes loading the film onto the
unwind shaft easier.
Figure 5.3.2 Unwind shaft
Core chucks
Core support
Clevis pin
Brake adjust knob
Roll of laminate
Saddle
d) Onceloaded, swing the unwind shaft back into
the saddle.
Ensure the roll of laminate is loaded
properly on the unwind shaft.
Exposed adhesive should be facing
away from the rollers.
This will prevent hours of roll cleaning!
CAUTION
