© GBC Pro - Tech August 1999
Page 6 - 70
F - 160 Operation and Maintenance Manual
Applications
Pass 1: Decal
Use Chart 9 and Diagram 9 for assistance.
Materials needed
• Roll of thermal laminate
• Roll of mount adhesive ( same width as the
laminate )
• Print ( smaller than the laminate )
• Roll of masking tape
• Utility knife
• Cutting blade with an enclosed casing.
• Piece of cardboard ( film width x 6” )
Set up
a) Turn MAIN POWER to “ON”. Refer to
Figure 6.8.1
b) Press RESET. Refer to Figure 6.8.1
Figure 6.8.1 MAIN POWER / RESET
Rear of the laminator
M A I N P O W E R
R E S E T
c) Ensure that the rear pull rollers are in the up
position..
d) Raise the front and rear safety shields.
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
W A R N I N G
e) Lift the clevis pin located in the saddle of the
upper unwind shaft.
Clevis pin
Saddle
f) Swing the upper unwind shaft out enough to
slide the roll of laminate over the core chucks
on the upper unwind shaft. Refer to Figure
6.8.2
