© GBC Pro - Tech August 1999
Page 6 - 62
F - 160 Operation and Maintenance Manual
Applications
Figure 6.7.1 MAIN POWER / RESET
Rear of the laminator
M A I N P O W E R
R E S E T
g) Lift the clevis pin located in the saddle of the
upper unwind shaft.
Clevis pin
S a d d l e
h) Swing the upper unwind shaft out enough to
slide the roll of thermal laminate over the core
chucks and onto the upper unwind shaft. Refer
to Figure 6.7.2.
INFORMATION
Twisting the roll of thermal laminate
while sliding makes loading the film
onto the unwind shaft easier.
Figure 6.7.2 Unwind shaft
Core chucks
Core support
Clevis pin
Brake adjust
knob
Roll of
Thermal
laminate
Saddle
i) Once loaded, swing the upper unwind shaft back
into the saddle.
Ensure the roll of laminate is loaded
properly on the unwind shaft.
Exposed adhesive should be facing
away from the rollers.
This will prevent hours of roll cleaning!
CAUTION
j) Push the clevis pin back down to secure the
unwind shaft in its saddle.
k) Lower the rear safety shield.
