Safety
F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999
Page 1 - 10
Ensure the roll of laminate is loaded
properly on the unwind shaft.
Exposed adhesive should be facing
away from the rollers.
This will prevent hours of roll cleaning!
CAUTION
INFORMATION
For the lower unwind shaft, add 1/4 in. to
t h e m e a s u r e m e n t .
INFORMATION
When requiring top and bottom heat, it is
recommended to set both temperatures to
the same set point.
INFORMATION
Do not add PRESSURE when heating the
laminating rollers, this allows the high
release silicone to expand with minimum
restrictions.
Slow speed will assists with heat up times
and distributes heat evenly.
INFORMATION
INFORMATION
When the laminator is first turned on, the
front control panel will go into the default
mode.
Default mode; TOP TEMP. = 68
o
F ( 20
o
C ),
BOT. TEMP. = 68 oF ( 20 oC ), GAP = 1 in.,
PRESSURE = no bars are solid, JOB = 0, no
motion direction selected, SPEED = 00.0 and
SLEEP = flashing
W A R N I N G
Keep hands and fingers clear of the
laminator roller nip when changing GAP.
Y o u c a n b e C R U S H E D o r B U R N E D !
INFORMATION
When storing parameters within the JOB
S A V E f e a t u r e o f t h e l a m i n a t o r , P R E S S U R E
is not a storable setting.