F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999
Page 6 - 69
Applications
This will prevent any activated adhesive
from contacting the rollers.
INFORMATION
c) Remove the roll of material from the upper
unwind shaft.
d) Trim as necessary.
e) Clean the rollers as described in the
maintenance section. ( Section 8.2 Cleaning
the rollers )
f) Lower the front and rear safety shields and
press SHUTDOWN if finished with the
laminator.
S E L
S A V
S H U T D O W N
0
J O B
End of application
6.8 Thermal decal and
mount
This is a two pass mount and laminate process.
Two pass meaning that the print will pass through the
laminator twice. The first pass ( Decal ) will apply a
mount adhesive to the back of the print while applying a
laminate to the front of the print. The second pass
( Mount ) will adhere the decal to a substrate.
The first part of this application ( Decal ) can
only be performed from the front of the laminator using
the main rollers. Use Chart 9 and Diagram 9 for
assistance.
The second part ( Mount ) is described from
the rear of the laminator since the main rollers are
heated. Use Chart 10 and Diagram 10 for assistance.
This application can be performed in various
methods. The process described in this manual is the
most common method.
W A R N I N G
Do not wear ties, loose fitting clothing or
dangling jewelry while operating or
servicing the laminator. These items can get
caught in the nip and choke you or you can
be crushed or burned.