57
Note:
When pushing down the tank you will see that the valve cover opens upwards.
Before the first use, you should operate the appliance without coffee. The internal
components of the appliance will be heated and purged. Follow the instructions
according to the section ›Preparing a Coffee‹.
PREPARING THE APPLIANCE FOR OPERATION
WARNING:
Never leave small children unsupervised with the appliance or the
parts of the appliance! Always make sure that the appliance is properly and fully
assembled and the selector switch is positioned on standby (centre) before plugging
the power cord into the outlet and turning on the appliance.
ATTENTION:
If the selector switch is positioned to the right (in brewing position),
after preheating, hot water emerges from the group head. If the selector switch is
positioned to the left (steam/hot water), hot steam or hot water (depending on the
setting) emerges from the steam wand. Make sure that the black folding switch is in
the correct position: steam or hot water.
Make sure to position the selector switch to the ›Standby‹-postition (middle) first. Press
the ›on/off‹-switch and turn on the appliance. The power indicator lights red. During
preheating the heating indicator lights red. Once the appliance is ready for operation
the heating indicator turns off.
Note:
Always turn the appliance off with the ›on/off‹-switch, unplug the power cord and
wait until the appliance has cooled down before removing/replacing or cleaning
the appliance water tank or drip tray.
Keep the workstation clean and dry. Do not let any liquids run above or below the
appliance or place towels, napkins, or similar materials under or on the appliance.
If during operation liquids have run on the appliance, turn off the power immediately
and unplug the power cord. Dry the appliance according to the instructions in sec-
tion ›Care and Cleaning‹.
To ensure that the thermal system and all inside pipes of the appliance are pre-hea-
ted and have the required operating temperature, the appliance shoud be prepared
accordingly.
1. Fill the water tank (as described) up to the MAX-mark (1500 ml).
2. Turn the appliance on by pressing the ›on/off‹-switch and position the steam
wand towards the drip tray. The power indicator lights red. During preheating