Garmin GNS 530W, Руководство по установке

Страница: 85 / 216

500W Series Installation Manual Page 5-7
190-00357-02 Rev. D
Terrain
Select Terrain in the CONFIGURE field to select the
TERRAIN TYPE (NONE, TERRAIN, or TAWS).
To test the Terrain Data Card, highlight the TEST
CARD field and press the ENT key. Verify that the
TEST CARD field indicates “PASS”. A “FAIL”
condition indicates that the Terrain Data Card is
unusable.
Note that if “TAWS” does not appear in the HW
CONFIG field, then the unit is not a TAWS capable unit.
Selection Description
None
No terrain functionality (TERRAIN or TAWS) is configured.
TERRAIN
The unit is configured for TERRAIN capability.
TAWS
The unit is configured for TAWS capability.
Discretes
Select Discretes in the CONFIGURE field to configure
the operation of specific discrete outputs.
GPS SELECT
Selection Description
Auto
When in GPS mode, the GPS Select discrete is unasserted (open)
whenever a GPS approach mode is active – no associated messages
appear and no pilot action is required. The pilot is also allowed to
select automatic or manual GPS to ILS CDI transitions on the AUX
CDI/ALARMS page.
Prompt When in GPS mode, the GPS Select discrete is unasserted (open)
whenever a GPS approach mode is active and the pilot has enabled
the A/P APR Outputs (an associated message is displayed telling the
pilot to enable the A/P APR Outputs). This setting will not allow the
pilot to select automatic GPS to ILS CDI transitions on the AUX
CDI/ALARMS page (only manual transitions are permitted).
For Honeywell (Bendix/King) KFC 225 and KAP 140 autopilots.
NOTE
The GPS SELECT setting affects autopilot mode transitions and must be reflected in the
AFMS. Refer to Section 5.8 for details.
Figure 5-4. MAIN SYSTEM CONFIG
Page
Figure 5-5 . MAIN SYSTEM CONFIG
Page