Garmin GNS 530W, Руководство по установке

Страница: 75 / 216

500W Series Installation Manual Page 4-21
190-00357-02 Rev. D
4.9 RMI/OBI
4.9.1 RMI/OBI Function
The MAIN OBI output provides bearing information from the active waypoint for Bendix/King Serial
OBI devices based upon the 500W Series unit’s GPS navigation. For the GNS 530W, the MAIN OBI
output may be configured so that it sends VOR/ILS bearing information when VLOC is selected by the
GNS 530W CDI key.
The VOR OBI output provides bearing information from the currently tuned VOR station for
Bendix/King Serial OBI devices based upon the GNS 530W VOR receiver. When a localizer channel is
tuned on the VLOC window, there is a bit in the data stream set to indicate that a localizer frequency is
tuned which stows the needle or drive it to the 3 o’clock position.
4.9.2 RMI/OBI Electrical Characteristics
Pin Name Connector Pin I/O
MAIN OBI CLOCK P5001 43 Out
MAIN OBI SYNC P5001 45 Out
MAIN OBI DATA P5001 44 Out
Pin Name Connector Pin I/O
VOR OBI CLOCK P5006 25 Out
VOR OBI SYNC P5006 26 Out
VOR OBI DATA P5006 27 Out
The output driver is active low. The driver output voltage is not more than 1.0 V when sinking 20 mA.
The maximum off state leakage current with respect to ground is less than 10
μ
A.
4.9.3 RMI/OBI Configuration
For the GNS 530W, see Section 5.3.9 for the MAIN OBI source configuration.
4.9.4 RMI/OBI Calibration and Checkout
Refer to Section 5.5.7.11 for calibration and checkout.
4.9.5 RMI/OBI Interconnect
Refer to Figure H-20 for the RMI/OBI interconnect.