Garmin GNS 530W, Руководство по установке

Страница: 49 / 216

500W Series Installation Manual Page 3-9
190-00357-02 Rev. D
3.10 Antenna Installation and Connections
3.10.1 GPS Antenna
This section provides information on the antenna cable installation. For mounting of the GPS Antenna
refer to the Garmin GA Antenna AML STC SA01695SE. Refer to 2.4.1 herein for installation location
considerations.
NOTE
The internal 500W Series unit COM does not interfere with its own GPS receiver.
However, placement of the 500W Series unit antenna relative to other COM transceivers
and antennas (including the 500W Series unit COM antenna) is critical.
Suggestion: Temporarily locate the GPS antenna with coax connected to the 500W Series unit and check
the GPS performance as described in Section 5.5.2 and Section 5.5.3. Once a suitable location has been
verified, then permanently mount the antenna.
Once the antenna mounting position has been prepared, route the coax cable from the antenna to the
500W Series unit. Proper selection of coax cable and assembly of connectors is critical to GPS signal
performance. The cable loss from the GPS antenna (excluding antennas in Table 1-3) shall be
between 1.5 dB and 6.5 dB in order to maintain proper rejection to interference signals.
NOTE
GPS antennas in Table 1-3 require a cable loss between 3 dB and 7 dB.
The coaxial connectors and adapters, such as TNC to BNC, add additional loss to the cable and should be
considered when computing the cable loss. A typical loss of 0.2 dB can be used for each connection. To
maintain integrity of the WAAS signal, the GPS antenna coaxial cable must have a minimum of two
shields (e.g. RG-400 or RG-142B).
NOTE
If RG-142B or RG-400 is used, 1.5 dB equates to a length of approximately 6.5 feet of
cable with a connector on each end. RG-142B or RG-400 cable can be used as long as the
length is less than 35 feet. For longer lengths, use low-loss double or triple shielded 50
Ω
coax.
For very short runs, where the loss is less than 1.5 dB, additional cable should be used to increase the
loss to within 1.5 dB to 6.5 dB. This additional cable may be coiled, taking into account the minimum
bend radius of the cable.
During the post-installation checkout, susceptibility to harmonics of VHF COM transmitters will be
evaluated. If problems arise, then better isolation, or distance, may be required between the GPS and
COM antennas, or a 1575.42 MHz notch filter may be installed in series with the antenna coax of the
VHF COM transceiver to reduce or eliminate the harmonic interference. A notch filter for this use (P/N
330-00067-00) is available from Garmin.
If a VHF COM transmitter causes problems with the GPS on the selected frequencies as listed in the
post-installation checkout, the problem may be due to the ELT. This can be verified by disconnecting the
ELT antenna coax at the ELT unit. If the ELT is found to cause the problem, then contact the ELT
manufacturer or replace the ELT.