MG6000 Series Media Gateway User
’
s Manual
- 41 -
4.2.8.2
Add number route mapping
Click
“
Add
”
to add routing map. This page is shown as below.
Fig. 4-13 add route map
All kinds of users could enter this page; all the users have the authorization to configure except common
users.
All the digit map parameters which had been modified, will take effect immediately but make sure the
modified can be applied next time, please save the configuraion, if you have modified the parameters.
The parameter show as below:
a). Index: new item
‘
s number.
b). Prefix: select this option and fill the
“
Number
”
box with the prefix number. That means the calls begun
with the prefix will use this route. Otherwise the number means the just call number that you dial.
c). Length: when
“
Prefix
”
is disabled, this box will automatically display the length of the
“
Number
”
your
type. Otherwise user could set the
“
Length
”
himself or select
“
Uncertain
”
length.
d). Routing type:
IAD series supports 4 kinds of route type: SIP(by IP),TEL connection, FXO connection
and FXO connection, however, The MG6008 just supports SIP(by IP) and TEL connection.
1). SIP(by IP)
If you enable the SIP route, the parameters such as
“
Peer IP
”
,
“
Peer port
”
,
“
Interception Length
”
and
“
Num(pre)
”
can be configured, the other can not be configured.
2). TEL connection
If the number that you dial use the tel URL format, you should select the TEL connection, and if enable
the TEL connection route, the parameters such as
“
Peer IP
”
,
“
Peer port
”
,
“
Interception Length
”
,
”
Phone-context
”
and
“
Num(pre)
”
can be configured, the other can not be configured.
3).FXS connection
If the type of port is FXO, FXS connection is effective, if enable the FXS connection, the parameters
such as
“
Interception Length
”
,
“
Num(pre)
”
can be configured, the other can not be configured.
4). FXO connection
If the type of port is FXO, FXS connection is effective.
