MG6000 Series Media Gateway User
’
s Manual
- 7 -
e) 10/100Base-TX: two 10/100Base-T Ethernet ports, supporting auto-negotiation. The port type is RJ-45.
The two Ethernets could connect to switch or hub by straight line, or connect to the computer by
crossover cable.
f)
RS232 interface: interface type RJ-11, used for setting data;
Instruction
：
Phone interface by matching the FXS mouth or FXO can not be told directly from the appearance, it need to be
read from network management.
2.1.4
Setting
In order to set up equipment more easily, MG6002 (2) has been set up two groups of digital switch: mandatory
follow-switching PSTN calland the system started selection switch. PSTN switch is in the back panel. When the
switch transfers to PSTN, compulsorily, all outbound calls of FXS mouth will be transferred to FXO through
PSTN; when the switch transfers to VoIP, uncompulsorily, all outbound calls of FXS mouth will pass VoIP or
PSTN will be divided by the dail setted by the equipment. System starting the choosing switch is to manage
network if the IP addressof equipments is unknown and cannot been connected. Usually it doesn
’
t need to be set,
the system-choose switch is inside the equipment and it
’
s not able to set up directly. The switch is call-switching
with 4 positions.
The digital switch-activated system of choice with the results and equipment port configuration is shown in Fig
2-2:
Sheet 2-1 selection switch-activated system
Position
Values
Description
ON
start from the smallest system (reserved)
1
OFF
Start normally. (Factory settings)
ON
Use default IP
2
OFF
Use setting IP
（
Factory settings
）
3,4
configuration settings
a) 3
＝
OFF
，
4=ON, set to be 2FXS
。
b) 3
＝
ON
，
4
＝
OFF
，
set to be 1FXS
＋
1FXO
。
2.2
Introduction of MG6004
MG6004 is a single board, the appearance is exquisite and light and the maximum capacity is four lines, the
users
’
interface type can only be FXS; MG6004 also has two 10/100 Base-T Ethernet interface, with two-story
wire-speed switching functions, users can save hubs (switch). In addition, a 10M I is saved for backup.
2.2.1
Appearance
