Game Composites GB1 GameBird, Руководство по обслуживанию

Страница: 99 / 269

Maintenance Manual GB1 GameBird
Page date: April 24, 2020
25-4
3. Stitching:
A. Broken or missing stitches
B. Severe fading or discoloration. (see 1B above)
C. Inconsistent pattern or thread size. Structural thread size should be the same throughout the
entire harness. Irregular patterns or varied sizes may be indicative of field modification.
4. Labels:
A. Missing or damaged
B. Illegible
If any of the above damage exists the belts should be replaced or repaired.
Repairs must be performed by an authorized facility which must be capable of returning the belts to the
original design configuration. In most cases if there is webbing and hardware damage, it will be more
economical to replace rather than repair.
Any questions about serviceability of the harnesses should be directed to the original manufacturer for
determination.
Rear seat shoulder belt
1. For access to the shoulder belt retaining tube, open the baggage door
2. Remove the two screws at the top of the seat which attach the shoulder belt tube to the fuselage
3. Maneuver the tube to allow the shoulder belt to be slid off
4. Conduct service as required
5. Slide belts through bulkhead opening, over retaining tube
6. Install fasteners to keep retaining tube in place
Signature
7. Check for correct assembly
Lap belt rear seat
1. Through the service panel in the baggage bay floor, remove retainer screw to allow lap belt retaining
tube to slide backwards
2. Slide lap belt retaining tube back
3. Remove belt
4. Conduct service as required
5. Slide belts in place, push retaining tube fully in, rotate retaining latch in place
6. Install fastener
Signature
7. Check for correct assembly
Front shoulder belt
1. For the front seat to access the shoulder belt bar, remove the antenna cover from the top of the rear
instrument panel
2. Remove the two screws at the top of the seat which attach the shoulder belt tube to the fuselage
3. Maneuver the tube to allow the shoulder belts to be slid off
4. Conduct service as required
5. Slide belts through bulkhead opening, over retaining tube
6. Install fasteners to keep retaining tube in place
7. Reinstall antenna cover
Signature
8. Check for correct assembly
Lap belt front seat
1. Through rear cockpit foot wells, remove AN3 retainer screw to allow retaining tube to slide backwards
2. Slide lap belt retaining tube back
3. Remove belt
4. Conduct service as required
5. Slide belts in place, push retaining tube fully in, rotate retaining latch in place
6. Install fastener
Signature
7. Check for correct assembly