Game Composites GB1 GameBird, Руководство по обслуживанию

Страница: 254 / 269

Maintenance Manual GB1 GameBird
Page date: April 24, 2020
73-6
Installation and adjustment:
1. Install Rod End Bearings on one end of cables 1 to 6 as shown to the right.
2. Connect cables 1, 2 and 3 to aft throttle quadrant
3. Maneuver cables and throttle quadrant in place
4. Secure aft throttle quadrant as shown
5. Connect cables 4, 5 and 6 to front throttle quadrant
6. Maneuver cables and throttle quadrant in place
7. Secure front throttle quadrant as shown on Fig. 73-2
8. Install cable couplings and jam nuts on threaded ends of cable 1, 2 and 3;
count 6 turns, threaded connecting holes in couplings oriented horizontally
9. Move all levers on both throttle quadrants 2mm (1/16”) from forward stop
10. Install cable couplings on threaded ends of cable 4, 5 and 6, adjust until connecting
holes align with couplings for aft throttle quadrant
11. If necessary, adjust that front and rear levers reach front and rear stops in both
quadrants at the same time
12. Connect couplings as shown on Fig. 73-3
13. Install cables 7, 8 and 9 into firewall Fig. 73-4
14. Install forward retention of cable 7 as shown on Fig. 73-5 below
15. Install forward retention of cable 8 as shown on Fig. 73-6 below
16. Install forward retention of cable 9 as shown on Fig. 73-7 below
17. Connect to respective couplings as shown on Fig. 73-3
18. Install rod end bearings on front end of cables 7, 8 and 9
19. Adjust and connect throttle as shown on Fig. 73-5
20. Adjust and connect propeller as shown on Fig. 73-6
21. Adjust and connect mixture as shown on Fig. 73-7
22. Function check:
a. Move throttle to idle stop. Lever on fuel servo must hit stop while both throttle levers must
have no less than 2mm travel to aft stop in each quadrant.
b. Move throttle to forward stop. Lever on fuel servo must hit stop while both throttle levers
must have no less than 2mm travel to forward stop in each quadrant.
c. Move prop lever to low RPM. Lever on prop governor must hit stop while both throttle levers
must have no less than 2mm travel to aft stop in each quadrant.
d. Move prop lever to high RPM. Lever on prop governor must hit stop while both throttle
levers must have no less than 2mm travel to forward stop in each quadrant.
e. Move mixture to cut-off. Lever on fuel servo must hit stop while both throttle levers must
have no less than 2mm travel to aft stop in each quadrant.
f. Move mixture to full rich. Lever on fuel servo must hit stop while both throttle levers must
have no less than 2mm travel to forward stop in each quadrant.
Fig. 73-5 Throttle Control Cable, sleeve retention bracket and connection to Fuel Servo