Game Composites GB1 GameBird, Руководство по обслуживанию

Страница: 175 / 269

Maintenance Manual GB1 GameBird
Page date: April 24, 2020
33-2
Anti-Collision Lights
The airplane is equipped with anti-collision strobe / position
light assemblies mounted to the plane outboard surface of
each wing tip. Each assembly consists of:
-
Navigation lights, red (LH wing) or green (RH wing), 6 LEDs.
- Anti-collision strobe light, 21 LEDs.
- White position tai lights, 5 LEDs.
Type: Andromeda Daylite, AVE-ADSSYWR-D01
Manufacturer: Aveo Engineering Group, s.r.o.
Pribram Airport, Drasov 202,
261 01 Drasov, Czech Republic
www.aveoengineering.com
All functions of the anti-collision strobe / position light lights are controlled
through one 7.5A ACL circuit breaker switch on the Switch Panel in the rear cockpit, 12VDC is provided via the
Avionics (Non-essential) Bus.
Shielded 4-core AWG22 wire is routed from the CB switch to the wing root ribs, quick-disconnect 4-terminal
cannon plugs are installed aft of the aileron control rod cut-out. The cables are routed rubber grommets
through the aft wing ribs up to the light assemblies.
For wiring and connection details, refer to section 24-03
No regular maintenance is required for the units.
The external surfaces of the lights may be polished with an automotive cleaner wax and/or a liquid polishing
compound. An electric buffing machine with a lamb’s wool cover may be used for deeper cleaning and
polishing. Do not use petroleum-based product to clean the lights.
The airplane is certified for day VFR only.
Subject to local regulations, the non-flashing red-green-white elements are not required to be functional.
If 6 or more LEDs in the strobe unit are defective, the unit has to be replaced.
Troubleshooting:
Trouble – Anti-Collision Lights Probable Cause Remedy
One or both units inoperative Cables damaged Repair or replace cables
Connectors damaged or
contaminated Clean or replace connectors, refer to section
24-03 and 24-03 for access
CB switch or connections /
terminals damaged Replace CB switch
Replace terminals
No power Check power on avionic bus
For additional troubleshooting information see section 24-11 .
To replace either Anti-Collision Light:
1.
Remove fasteners
2. Use blade to cut through Sikaflex adhesive / seal, pull off anti-collision light, disconnect cable
3. Connect new anti-collision light, ensure correct color: red on LH wingtip, green on RH wingtip
4. Apply thin bead of Sikaflex around contact area; for details, refer to 51-11
5. Use fasteners to mount anti-collision light to wingtip
6. Remove excessive Sikaflex
7. Let Sikaflex cure overnight
8. Conduct function check:
a. Battery Master ON
b. ACL Switch ON
c. Lights Function visually check
CAUTION: To prevent eye injury, wear welding goggles to check LEDs!
d. ACL Switch and Battery Master OFF